Änderungen

Zur Navigation springen Zur Suche springen
keine Bearbeitungszusammenfassung
delay(1000);
}
 
== Vergleich der Stile ==
 
{| class="wikitable" border="5"
|-
! AH-Stil !! Arduino-Stil
|-
|<pre>
/* blink.ino - Schaltet eine LED für eine Sekunde an, dann wieder für
* eine Minute aus.
* Die meisten Arduinos haben eine eingebaute LED, die du
* ansprechen kannst. Auf dem UNO, MEGA und ZERO ist sie
* an PIN 13 angeschlossen, auf dem MKR1000 an PIn 6.
* LED_BUILDIN wird je nach Board auf den richtigen Wert
* gesetzt.
*
* 2014-05-08 Scott Fitzgerald angelegt
* 2016-09-02 Arturo Guadalupi Kommentare ergänzt
*
**********************************************************************/
 
// the setup function runs once when you press reset or power the board
void setup ()
{
// initialize digital pin LED_BUILTIN as an output.
pinMode (LED_BUILTIN, OUTPUT);
}
 
// the loop function runs over and over again forever
void loop ()
{
digitalWrite (LED_BUILTIN, HIGH); // turn the LED on (HIGH is
// the voltage level)
delay (1000); // wait for a second
digitalWrite (LED_BUILTIN, LOW); // turn the LED off by making
// the voltage LOW
delay (1000); // wait for a second
}
</pre>
|
<pre>
/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.
 
Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO
it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN takes care
of use the correct LED pin whatever is the board used.
If you want to know what pin the on-board LED is connected to on your Arduino model, check
the Technical Specs of your board at https://www.arduino.cc/en/Main/Products
This example code is in the public domain.
 
modified 8 May 2014
by Scott Fitzgerald
modified 2 Sep 2016
by Arturo Guadalupi
*/
 
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin LED_BUILTIN as an output.
pinMode(LED_BUILTIN, OUTPUT);
}
 
// the loop function runs over and over again forever
void loop() {
digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(LED_BUILTIN, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}
</pre>
|}
101Sensoren, Editor, Bürokraten, Administratoren
127

Bearbeitungen

Navigationsmenü